BAMSBUNG NO REPAINT Indicator is good for scalping. you can trade any time frame, any currency pairs with it. After, load indicator Allow DLL imports. Before you begin Forex trading you must carefully learn what is Forex trading. If not you will be a loss. Use the Currency Strength indicator to get a better result. This indicator is good for scalping.
How to install the Forex Bamsbung indicator.
Download indicator> open meta trader forex plat form> go file menu> open data folder> open MQL4> open indicator> insert indicator> open libraries> insert dll.file> re start meta trader platform.Insert indicator to currency chart & allow DLL imports. Then you can enter to trade with Bamsbung no repaint indicator. As an additional feature, you can use moving average or support resistance lines or any trend identifier indicator as you wish. So you can filter trends & avoid false signals. you can exit the trade with the opposite signal or target profit pips.
For the best result, add support resistance indicator. Then if you want to enter a buy trade wait until Forex bamsbung arrow appears near the support line.
Once price moves up from the support line & then arrow appears, at that time you can enter to buy trade. If you want to enter a sell trade wait until the forex bamsbung arrow appears near the resistance line. once price moves down from resistance level & then down arrow appear at that time you can enter a sell trade. Don’t enter to trade while high impact news time. on that time market volatility can be increased & you will get so many false signals. So stop trade before half & hour from high impact news. Enter again to trades after half & hour from high impact forex news. Select a good forex trading session as you wish. Don’t enter to trade every time.
White Arrow. – Below forex price
White Arrow. – Over forex price
Set SL. as you wish.
Excellent post however , I was wanting to know if you could write a litte more on this subject? I’d be very grateful if you could elaborate a little bit further. Appreciate it!
Thanks .my dear, I will write more about it……….
arrow not show
put the dll.files to libraries folder. After you load indicator allow DLL imports in common section & show arrows must be true in the inputs. Then change the time frame & zoom chart.
you must activate (show arrows) in input of indicator settings.